Body fat calculator

Body-fat percentage from the U.S. Navy tape method, plus fat mass and lean mass if you add your weight.

Free. No account required.

Waist at the navel. 70 in is 5 ft 10 in.

How the calculation works

The equations are from Hodgdon and Beckett at the Naval Health Research Center (1984). They estimate body density from height and tape measurements, in centimeters. Inches are multiplied by 2.54 first. Percent fat then comes from the Siri equation those reports use: 495 divided by density, minus 450.

Men use the waist at the navel minus the neck. Women use the narrowest part of the waist, plus the hips, minus the neck. The neck tape sits just below the larynx and slopes slightly down toward the front. Hips are the greatest protrusion of the gluteal muscles. In the original measurements people stood relaxed, the tape touched the skin without pressing in, and the waist was taken at the end of a normal breath out.

Against underwater weighing, the men's equation had a correlation of 0.90 and a standard error of 3.52 percentage points. The women's equation had a correlation of 0.85. A later Navy comparison with DEXA, in 51 men and 51 women, found standard errors of 2.1 and 2.3 points. In that group the women's tape average was 36.1% and the DEXA average was 32.6%. One person can be farther off than the average error. A DEXA scan is a different measurement, with its own error.

If you enter weight, fat mass is that weight times the percentage. Lean mass is the remainder. It includes bone, water, and organs, not muscle alone. The macro calculator can use the percentage and the weight for protein. The TDEE calculator estimates maintenance from scale weight, height, age, and activity.

A worked example

A man who is 70 in tall, with a 15 in neck and a 34 in waist, comes out at 17.4%. At 180 lb that is 31.4 lb of fat and 148.6 lb of lean mass. The same tape in centimeters gives the same percentage.

Sources checked November 16, 2026: Hodgdon and Beckett, men, 1984; Hodgdon and Beckett, women, 1984; McClintock and colleagues, circumference vs DEXA, 2021; American Council on Exercise, body-fat ranges.

Common questions

How do I measure?

Stand relaxed. Put the neck tape just below the larynx, sloping slightly down toward the front. For men, measure the waist at the navel. For women, measure the waist at its narrowest point, about halfway between the bottom of the breastbone and the navel, and the hips at the widest part of the gluteal muscles. Keep the tape level except at the neck, snug but not pressing into the skin, and take the waist after a normal breath out.

How close is this to a DEXA scan?

It is a prediction from a tape, built against underwater weighing. For the men in the original Navy sample the standard error was 3.52 percentage points. A 2021 Navy comparison with DEXA in 102 sailors still found errors of a couple of points, and the women in that sample averaged higher on the tape than on DEXA. Tape placement, body shape, and the day you measure all move the result.

Why do women enter hips and men do not?

The women's equation was the one that used hip circumference along with the natural waist and the neck. The men's equation uses the navel and the neck. Measuring a man at the narrowest waist, or a woman at the navel, feeds the equation a site it was not built on.

What do the categories mean?

They are the American Council on Exercise chart, split by sex: essential, athletes, fitness, average, and obesity. This page labels the top band Above average. ACE's obesity cut points are 25% for men and 32% for women. The chart is not a diagnosis, and it does not change with age. A result between two whole numbers stays in the lower band.

What if neck and waist do not make sense?

The men's equation takes the logarithm of waist minus neck. The women's equation takes waist plus hips minus neck. If that gap is zero or negative, there is no percentage to show, so the calculator asks you to check the tape and the units instead of returning a blank result.

Keep going